The article we offer describes in detail the types of hydraulic accumulators and provides rules for their selection. We have provided in detail how the equipment is installed and adjusted. The recommendations we provide will ensure trouble-free operation of the device and extend its service life.
A hydraulic accumulator, also known as a hydraulic tank, also known as a storage or pressure tank, are different names for the same device.
On the outside it is actually a metal tank, and on the inside lebanon mobile database container is divided into two parts by a special rubber gasket, which is sometimes called a membrane.
Image gallery Photos from Purpose of hydraulic accumulators Hydraulic tank as part of a pumping station Installation in a well caisson Hydraulic tank in tandem with a submersible pump Hydraulic accumulator for a deep well Location in the basement of a private house Automation of water pumping from a storage tank Hydraulic accumulator on a summer cottage
The gasket is firmly fixed at the neck of the tank, where the hole for water inlet is located. On the opposite side of the tank there is another hole, it is intended for air.
A regular nipple is installed here. What is all this for? The membrane divides the hydraulic tank into two sections. On one side of this gasket is water, and on the other side is air under a certain pressure.
A pressure gauge is used to measure the pressure in the hydraulic accumulator. Some models are additionally equipped with a filter to prevent contamination from getting inside. The membrane material is a special rubber. It is not only elastic, but also safe for human health.
The hydraulic accumulator is divided into two parts by a membrane. On one side of this insert there is water, and on the other side there is air under pressure, which allows creating pressure in the water supply system.
Operating principle of a typical hydraulic tank
-
zihadhosenjm40
- Posts: 521
- Joined: Sat Dec 21, 2024 3:33 am