Nozzles, air pressure regulators and sprayer filters should be checked regularly and any necessary maintenance and replacement performed. This will help extend the life of the sprayer and maintain spray quality.
Maintenance of oil supply system. If the air supply system of the spray cabinet is blocked or there is too much dust, the filter cotton should be replaced. The oil filter system behind the spray cabinet should be opened for cleaning about once every three days. At the same time, it is necessary to clean the oil and dirt of the conveyor network and add grease from time to time.
Maintenance of the oil supply system. After using the spray gun, close the paint return valve to make all the paint return to the ink tank, take out the ink tank and pour the cleaner into it, start the canada number data oil pump. Open the return valve and the spray gun to the maximum to make the cleaner circulate in the oil pipe and clean the spray gun and oil pump. The pump and spray gun are very precise, so do not disassemble them when cleaning to avoid damage.
After a week or 50 hours of operation, check whether the pump, cylinder and leather piston of the jetting machine are tight, the tension of the belt on the drive, the reliability and tightness of the pipe connections, clean the surface of the pump and apply thin motor oil to prevent dirt from sticking.
The clutch, backflow relief valve, gear reducer, air compressor and other main components should be checked regularly according to their use requirements. If they are worn or damaged, they should be adjusted and replaced in a timely manner.
Before filling the mortar mixer and mortar jetting machine, it is necessary to wipe off the dirt on the oil filling areas and oil holes.