a — marking the diagonal in a rectangular room, b — laying tiles of one color along the frieze with correct marking, c — laying multi-colored tiles along the frieze with incorrect marking, d — laying tiles at an angle in the center to form a single-color row along the perimeter of the frieze.
Laying tiles this way is not easy for a beginner. This layout makes sense because it is more decorative and visually increases the space. The disadvantages include not only the complexity of the cladding, but also the increased consumption of tiles due to the greater amount of waste.
There are several methods of diagonal laying. All of them require rectangular geometry of the area that will be given over to this type of layout. If the right angles in the room are not maintained, the outer tiles running along the perimeter along the walls will be cut unevenly. To avoid this, you can surround the central rectangular area with tiles arranged in the usual way (or a frieze). This will smooth out visual flaws. But this is a matter of taste.
The rectangle is marked out using cords and a tape measure. Opposite sides, like diagonals, should be equal. Having walked along the outer contour of the rectangle with tiles "seam to seam", you can start laying ceramics from the most visible place. The inner contour consists of alternating halves and whole tiles. Unlike the senegal mobile database method, cords should be pulled along two diagonals, forming a right angle.
Laying tiles
If the floor has not been waterproofed before, you will need to install a liquid barrier. Moreover, additional waterproofing will not hurt, do not rely on the builders of the house. If we are talking about tiling the floor in the bathroom, waterproofing is a must. It is not difficult to do, usually a dry mixture diluted with water is used. Mix according to the instructions and go over the surface of the floor with a brush, capturing the walls by 10-15 cm.
Once the waterproofing has completely hardened, you can start laying the tiles.
The glue is mixed with water in the proportions specified by the manufacturer and mixed for 3-5 minutes. The mixture should be left to sit for 10 minutes and mixed again before use.
The solution should be applied either to the tiles or to the base. If the room is large, the second option is more reasonable – the process goes faster. If the floor is small or it comes to cutting the tiles, it is better to coat the ceramics.
Before laying tiles on the floor,
-
- Posts: 521
- Joined: Sat Dec 21, 2024 3:33 am