The intersection points of the fillet and the slope are found

[zihadhosenjm40]

Using a flat metal spatula, carefully remove any stone chips from the surface. You need to make sure that the gluing area is absolutely clean and even. If the work is difficult, you can warm up the patches a little with a building hair dryer, but not too much. Otherwise, the material will become very soft and may be damaged.
The patch is heated with a hair dryer

Heat the corner of the fillet with a hair dryer, apply the patch to it and press firmly.
The corner of the fillet is heated with a hair dryer

Heat the patch again a little and carefully press it with great force onto the surface of the chimney. Make sure that the adhesion is strong and over the entire surface of the patch.
The patch is pressed tightly

It is recommended to seal the chimney france mobile database unit using patterns from the remaining pieces of valley carpet. In terms of its performance characteristics, it better meets modern requirements. In extreme cases, it is allowed to use patterns from the lining carpet.

Step 3. Place a piece of carpet at the bottom of the chimney, make marks on it along the width of the pipe. The length of the pattern should correspond to the sum of the sealing height on the chimney and the length of the material under the soft tiles. Practitioners recommend taking it with a reserve, a large length will not cause problems for further work, and too short a pattern can cause leaks. Put it in place, bend it and use your finger to find the connection points of the dumbbell with the slope and the chimney. You need to cut out the pattern at these points.


The height of the vertical should take into account the climatic conditions of the house location and the maximum height of the snow cover, but be no less than 30 cm, the horizontal height should be no less than 20 cm. The length of the dumbbell-shaped part should be added to these dimensions. The width of the pattern depends on the parameters of the pipe, the length of the side parts of the envelope should be no less than 20 cm.