Securely clamp the wires into the terminal clamp.
Posted: Sun Feb 09, 2025 4:25 am
Step 6. All strips of thermal film should be fixed together with tape to prevent shifting. Next, check the correct installation of the clamps and film, if everything is OK, then you can connect the power wires.
Connecting the installation wires to the contact clamp Connecting the installation wires to the contact clamp
To increase the service life, it is advisable to tin the bare ends. This not only improves contact at the connection points and prevents oxidation processes, but also increases the safety of using a warm floor. If there is insufficient contact, the clamps heat up strongly and can melt the linoleum. Burns to the feet, electric shock or fires are possible. All clamps with connected wires must be insulated with a special bitumen film on both sides. Carefully ensure that the silver contacts of the thermal film are completely insulated from below and above.
Example of correct installation of the nigeria mobile database
insulation sheet for contact clamps
Installing the top insulation sheet
View of an insulated contact clamp with wires connected
Step 7. Connection of the thermostat can be started only after careful reading of the attached instructions. The heating temperature sensor is mounted on the black strip of the thermal film, fixed with insulating tape. There are cases when it is installed above the floor and reacts to the air temperature inside the room.
Installing a floor temperature sensor
The sensor is attached to the thermal film with bitumen insulation.
Installed and glued floor temperature sensor. Bottom view of the thermal film
Connecting the installation wires to the contact clamp Connecting the installation wires to the contact clamp
To increase the service life, it is advisable to tin the bare ends. This not only improves contact at the connection points and prevents oxidation processes, but also increases the safety of using a warm floor. If there is insufficient contact, the clamps heat up strongly and can melt the linoleum. Burns to the feet, electric shock or fires are possible. All clamps with connected wires must be insulated with a special bitumen film on both sides. Carefully ensure that the silver contacts of the thermal film are completely insulated from below and above.
Example of correct installation of the nigeria mobile database
insulation sheet for contact clamps
Installing the top insulation sheet
View of an insulated contact clamp with wires connected
Step 7. Connection of the thermostat can be started only after careful reading of the attached instructions. The heating temperature sensor is mounted on the black strip of the thermal film, fixed with insulating tape. There are cases when it is installed above the floor and reacts to the air temperature inside the room.
Installing a floor temperature sensor
The sensor is attached to the thermal film with bitumen insulation.
Installed and glued floor temperature sensor. Bottom view of the thermal film